[WT-support] problem comunication WT via micoHAM USB III -IC7700

[9A5K]

Tonno,

default address for PRO III is 6E, if I remember it OK.

However, he can check that in OTHER menu on TRX, where other communication parameters are show (CI-V, baud rate etc.)..
Check the rate in TRX too..

73,
Chris - 9A5K
  ----- Original Message ----- 
  From: Tõnno Vähk 
  To: support at win-test.com 
  Sent: Tuesday, October 26, 2010 11:21 AM
  Subject: Re: [WT-support] problem comunication WT via micoHAM USB III -IC7700


  Actually ES5RY was having problem to get IC756 PROIII CAT to work. USB Router shows frequency and everything is fine but Win-Test does not read CAT.

   

  He used MK2R+ and settings:

   

  19200, 8, N, 1. Address 50h. No settings in WT worked (CI-V on/off, handshake, always on/off, tried 4800 rate in the rig and USB router.)

   

  Any idea why WT might not read CAT while all fine in USB router? (same port of course and USB router says port opened)

   

  Can it be the problem of the address? Is 50h correct for PRO III?

   

  73

  Es5tv

   

  From: support-bounces at win-test.com [mailto:support-bounces at win-test.com] On Behalf Of Bob Wilson, N6TV
  Sent: Tuesday, October 26, 2010 12:13 PM
  To: support at win-test.com
  Subject: Re: [WT-support] problem comunication WT via micoHAM USB III -IC7700

   

  On Mon, Oct 25, 2010 at 9:44 PM, sp7idx <sp7idx at interia.pl> wrote:

   CI-V Baud Rate 19200
  CI-V Address 7Ah   <<<<<<<<<<<<<
  CI-V Transceive ON
  Decode Baud Rate 19200

   

  After several private messages back and forth, I finally noticed that this not the default CI-V  address for an IC-7700.

   

  Waldi changed the CI-V address back the default, 74h, then Win-Test worked fine.

   

  73,

  Bob, N6TV



------------------------------------------------------------------------------


  _______________________________________________
  Support mailing list
  Support at win-test.com
  http://www.f5mzn.org/cgi-bin/mailman/listinfo/support
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.win-test.com/pipermail/support/attachments/20101026/ab2b57f3/attachment.htm>