[WT-support] WT & Microham MK2R+

[Braco OE1EMS]

no real the wintest problem but i cann help somebody...(maybe)
"many times (from the begining) when i was in maual mode (switching audio or
TX focus by my self)
MK2R+ or wintest hang and i was not able to key any radio!"

acording to Josef OM7ZZ this happend because of no recieving data from TRX
maybe RFI, if MK2R+ dont get the freq data from TRX both radio will be 
inhibit
to protected QSY to same band (of course only if this option is set it in 
MK2R+ configuration program)

the RFI problem with MKII was resloved connecting of USB ground to MKII 
ground!

still did´t have chance to test again problem with altarnate cqing and 
secundary window in wintest!

73 de oe1ems


---- Original Message ----- 
From: "Braco OE1EMS" <oe1ems at emssolutions.at>
To: <support at win-test.com>
Sent: Sunday, March 16, 2008 11:03 PM
Subject: Re: [WT-support] WT & Microham MK2R+


hi mike and others,

i used for frist time Wintest (3.19) and MK2R+
in compare to EZMAster MK2R+ have much more possiblitoes but it´s very hard
to setup everything right!

i took me one day to study manual and setup and test configuration....
finaly no problem with CW and SSB mesages
but much other problems....
i used configuration with 2 foot switch each radio one with option "first
one wins"
many times (from the begining) when i was in maual mode (switching audio or
TX focus by my self)
MK2R+ or wintest hang and i was not able to key any radio!
finaly after some time MK2R+ was "frozen" no recation just some buzzer ton
from inside
off/on did´t help....try to restat MK2R software and wintest did´t help,
also no luck with rebuting PC
after disconectiong all cables from MK2R+  and  conecting everything again
after some time (10-20 min i think)
it start to work again but still  had same  problems with keying!

another problem was with alternate cqing
when i was in secondary radio window (logging using "caps lock binds
secundary radio")
and start with altarnate cqing scenario all cq where send it only to one
radio!
only possibility was to change to main logging window and start with cqing!

also few times i was not able to use auto sending fuction and auto cqing
when i was in secondary radio window ("caps lock")

CW was not so good using  clasic keying over MK2R+ comport (i think not very
good ratio between dots and dashes)
i change this to Winkey and this was UFB!

after 3-4 hours i give up and change setup to SO1R using MK II and made just
few more QSO´s in SO1R mode  till end of contest.....
it look like MKII have some problems with RFI...did notice this on 80m and
40m (only in SSB mode without using DVK)

i am still not sure, did i made some failures in MK2R+ or in WT
configuratins......or maybe some other kind of failure?!


73 de OE1EMS/T93J
Braco





----- Original Message ----- 
From: "Mike RL3BM" <rl3bm at rl3bm.ru>
To: <support at win-test.com>
Sent: Sunday, March 16, 2008 7:20 PM
Subject: [WT-support] WT & Microham MK2R+


> Hello, group!
> I'm looking for someone who is using Microham MK2R+ with WT. I just
> had my first experience with such setup in Russian DX contest (still SO1R
> for the present)
> and I have not been satisfied by some results, especially as to use of
> CW messages and SSB DVK messages.
>
> Regards
> Mike RL3BM
>
>
>
>
> _______________________________________________
> Support mailing list
> Support at win-test.com
> http://www.f5mzn.org/cgi-bin/mailman/listinfo/support

_______________________________________________
Support mailing list
Support at win-test.com
http://www.f5mzn.org/cgi-bin/mailman/listinfo/support