[WT-support] S&P V3.14.0

[Joerg Vollbrecht]

Olivier F5MZN schrieb:
> Hi Stewart,
>
>   
>> I am trying to migrate from N1MM to WT, so this weekend I tried  it in IOTA as
>> S&P. I was hoping that with the recent addition to WT of S&P the transition
>> would be easy. Either I am misunderstanding how it should work (most likely), or
>> there might be a bug. Actions were as follows:-
>>
>> Select S&P with ctrl - Tab. Shows in the clock window.
>> Bandmap properties set S&P options for Wipe the QSO and Populate the Bandmap.
>>
>> I expected that if I changed the radio frequency by greater than the Frequency
>> Change Threshold that the call I had manually entered would be transferred to
>> the Bandmap  display and the entry line wiped. This does not happen.
>>     
>
> Affirmative, that should work like you described as far as the S&P mode 
> is enabled. In RUN mode, nothing happens when you change the frequency. 
> I have confirmation from some users that it works that way, at least for 
> the primary radio (= active radio).
>
> Can you please verify again? If you are still not able to get it 
> working, could you send me direct to my home email adress your WT.INI file?
>
> Thanks and 73,
>   
My TT Orion II doesn't work that way either!
Setup: Orion II and microKeyer (firmware 3.2 and USB device router ver. 
4.0.10)

73
Joe, DL4CF