1-2 second delays are a common problem when using Win-Test with the microHAM control protocol, even with the older MK2R+.<br><br>Make sure you don't have PTT lead/tail delays set to the default values.  Use the <i>minimum</i> numbers (e.g. 0.0 if possible).  You have to set this in both the Router program and in the Win-Test Winkey Configuration screen (shortcut:  WKSETUP [Enter]).<br>

<br>Sometimes powering everything off and on in just the right sequence will correct the problem, e.g.:<br><ol><li>Power on computer</li><li>Wait for Router program to start (yellow X)<br></li><li>Power on microHAM box</li>

<li>Wait for Router to detect microHAM (Green check mark)</li><li>Turn on radios</li><li>Wait for microHAM Ports tab to display rig freq.<br></li><li>Start Win-Test</li><li>Issue two or three messages to see if thing speed up (first few messages may be delayed)</li>

</ol>If that doesn't help, verify that you are using the correct COM port settings in Win-Test Interface Configuration, e.g.:<br><ul><li>microHAM control port:  38400,N,8,1</li><li>WinKey port:  1200,N,8,2 Handshake/Handshake</li>

<li>Elecraft port:  4800,N,8,1 Always OFF/Always OFF</li><li>Yaesu port:  4800,N,8,2 Always OFF/Always OFF</li></ul>For radios, press the "Use xxx defaults" button on the Win-Test COM port setup screen.  Make sure both Win-Test and the microHAM box are talking to the rig with the same speed settings.<br>

<br>73,<br>Bob, N6TV<br><br><div class="gmail_quote">On Wed, May 12, 2010 at 1:58 AM,  <span dir="ltr"><<a href="mailto:sm5ajv@qrq.se">sm5ajv@qrq.se</a>></span> wrote:<br><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">

I am trying to get the new microHam micro2R (SO2R) box to work with WT<br>
and have run into some problems.<br>
<br>
When starting CQ by pushing F1 in WT it takes about 1 second<br>
before the actual CW output is started. Has anyone any hint<br>
on how to configure this new device with WT. I am using<br>
the MK2R setup for the Control Port.<br>
<br>
Pushing the test command for F1 on the router starts CW immediately.<br>
<br>
Any advices are most welcome!<br>
<br>
73<br>
Ingo SM5AJV / SE5E<br>
<br>
<br>
<br>
_______________________________________________<br>
Support mailing list<br>
<a href="mailto:Support@win-test.com">Support@win-test.com</a><br>
<a href="http://www.f5mzn.org/cgi-bin/mailman/listinfo/support" target="_blank">http://www.f5mzn.org/cgi-bin/mailman/listinfo/support</a><br>
</blockquote></div><br>