<div class="gmail_quote">On Fri, Aug 7, 2009 at 2:25 AM, Franco IZ4MJP <span dir="ltr"><<a href="mailto:franco@iz4mjp.com">franco@iz4mjp.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">


COM10 To G-800 SDX failed to open. Com Port Already in use?<br>
<br>
Obviously this port is not in use as all the softwares are not<br>
running and no one "ping" this port.<br>
<br>
I've tried some other setups in WT Rotor but the problem persist.</blockquote><div><br>Is Win-Test running when you get this message?  Try running only wtRotators.<br><br>If you exit Win-Test, and start <i>only</i> wtRotators, and the problem disappears, then chances are COM10 is being used by Win-Test itself instead of by wtRotators only.  Type SETUP [Enter] to go to the Configure Interfaces dialog, then look for COM10 and make sure it is set to "None".  Do <i>not</i> use "Other Interface" for the rotator port.<br>

<br>If you exit Win-Test and wtRotators still can't open COM10, chances are the USB to Serial device driver is not configured properly.  In Windows Start | Run | DevMgmt.msc and look under "Ports" to see the list of virtual and real COM ports that are known to Windows.<br>

<br>73,<br>Bob, N6TV<br></div></div>