<div class="gmail_quote">On Tue, Jul 21, 2009 at 2:06 PM, XABSS1 <span dir="ltr"><<a href="mailto:xabss1@gmail.com">xabss1@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">

hi folks,das the win-test software support rigexpert standard<br>
interface,thanks in advance,73 andy</blockquote></div><br>It looks like it should work, though I haven't tried it myself.  Searching the archives, few people seem to be using this device.  Some have had problems with rig control.  I see the RigExpert Standard has gone through a number of firmware upgrades:<br>

<br><a href="http://www.rigexpert.com/index?f=downloads">http://www.rigexpert.com/index?f=downloads</a><br><br>The RigExpert documentation says they use FTDI's FT2232C Dual USB UART/FIFO chip (USB to serial converter) and refers you to the FTDI web site <a href="http://www.ftdichip.com">http://www.ftdichip.com</a>.<br>

<br>According to the <a href="http://www.ftdichip.com/Documents/AppNotes/AN_104_FTDI_Drivers_Installation_Guide_for_WindowsXP%28FT_000093%29.pdf">FTDI documentation</a>, when you install the device driver, it defines two virtual COM ports (e.g. COM4 and COM5).  You would use one for rig control and one for CW/PTT.  In Win-Test SETUP, you would have to specify the use of those virtual COM ports, e.g. COM4 for Radio 1 and COM5 for CW/PTT.  There is no specific Win-Test support for the RigExpert itself, so you should use it just like any other USB-to-Serial interface.<br>

<br>The <a href="http://www.rigexpert.com/index?get=rep_manual.pdf">RigExpert manual</a> says:<br><br>"Please remember that since CAT and PTT/CW lines are located on <i>two different</i> COM ports, software<br><i>should </i>also be set to use separate ports for CAT and PTT/CW outputs."<br>

<br>BTW Andy, what is your callsign?<br><br>73,<br>Bob, N6TV<span style="font-family: Verdana;" lang="EN-GB"></span>