<div dir="ltr"><div>This sounds like a question for the Elecraft list, rather than the Win-Test list.<br><br>Try <a href="http://n2.nabble.com/Elecraft-f365791.html">http://n2.nabble.com/Elecraft-f365791.html</a><br><br>I found a lot of discussion about PTT and VOX that seems related to your question, but no clear answer.<br>
<br>See <a href="http://n2.nabble.com/K3-PTT-CW-td468135.html#a468138">http://n2.nabble.com/K3-PTT-CW-td468135.html#a468138</a><br><br>The manual says:<br></div><blockquote><blockquote style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;" class="gmail_quote">
Hold QSK to select full break-in (QSK icon on) or semi break-in operation.<br><br>VOX must be turned on in CW mode to enable both full and semi break-in operation. If PTT is selected (VOX icon off), transmit must be activated using PTT or by tapping XMIT.<br>
</blockquote></blockquote>I think the problem is that the K3 tries to force all external relays to close before any CW comes out.  So in PTT mode, if you are key down, then you press PTT, they can't enforce the keying delay, so they don't transmit?<br>
<br>My K3s should arrive soon, maybe then I can try it.<br><br><div>73,<br>Bob, N6TV<br><br><div class="gmail_quote">2008/8/19 Steef PA2A <span dir="ltr"><<a href="mailto:pa2a@xs4all.nl">pa2a@xs4all.nl</a>></span><br>
<blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">





<div bgcolor="#ffffff">
<div><font face="Arial" size="2">Gary,</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">I was testing the K3 next to my TS850 with a 
DigiKeyer and an USBII interface. I noted a little difference in the PTT 
behaviour of these two rigs.</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">VOX is set to PTT. If I only make CW, only the 
sidetone can be heard and there is no output (except some spurious) When I apply 
PTT while sending CW or keydown, the K3 still does not start to send. Stopping 
the CW signal with PTT on and starting again the K3 starts to send with power. 
This is different from the TS850 where the PTT works independant of the presence 
of a CW signal. Applying the signals via the normal connectors or via the RS232 
cable makes no difference.</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">Maybe there were reasons for this design and it is 
no problem for me, but there is a difference in PTT and CW between these two 
transceivers.</font></div>
<div><font face="Arial" size="2"></font> </div>
<div><font face="Arial" size="2">73 's Steef PA2A</font></div>
<div><font face="Arial" size="2">K3 #1184</font></div></div></blockquote></div><br></div></div>