<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD>
<META http-equiv=Content-Type content="text/html; charset=iso-8859-1">
<META content="MSHTML 6.00.6000.16481" name=GENERATOR>
<STYLE></STYLE>
</HEAD>
<BODY bgColor=#ffffff>
<DIV><FONT face=Arial>Hi Larry, Oliver</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>Larry - I spoke to you about this at Friedrichshafen. I
was hoping to catch Oliver, as you suggested, but I was led astray and never
quite made it to your desk in time.</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>You suggested that my situation, described below, may be
an FT-2000 thing. Can you confirm for me please - does it work differently or
the same with an FT-1000? i.e. does the bandmap focus follow the Tx
focus is on the radio? or does is act as described below?</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>I would appreciate your thoughts. This will help me
determine if its the radio interface or Win-Test working as
designed.</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>Thanks</FONT></DIV>
<DIV><FONT face=Arial>John G4IRN.</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial>==========================</FONT></DIV>
<DIV><FONT face=Arial>This year on NFD at G7EAR/p we used an FT-2000 with two
networked laptops running WT v3.11.<BR><BR>Laptop 'A' was connected to the
FT-2000 via the CAT interface and all worked well except for one thing, which I
suspect might be a 'working as designed' thing.<BR><BR>We were using 2 op 1
radio mode i.e. the main receiver and sub receiver were both active (the stereo
audio output was put through a splitter, one Rx VFO to each op). The active Tx
was mainly on the main VFO. (VFOa)<BR><BR>With this setup, WT on Laptop 'A' put
the focus on VFOb. If I clicked on VFOa on the band map, it switched off the sub
receiver.<BR><BR>With the transceiver in dual receive mode, the way it worked
made it impossible for the operator on VFOa to monitor the bandmap for VFOa
whilst tuning up and down the band (to see the freq of previous QSO's) and also
impossible to add spots (Ctrl Enter) for working later. Is it possible to set
this up some how?<BR>===================</FONT></DIV>
<DIV><FONT face=Arial></FONT> </DIV>
<DIV><FONT face=Arial> </DIV>
<DIV><BR></DIV></FONT></BODY></HTML>