<html>
<body>
<font size=3>At 06:40 PM 12/3/2006, you wrote:<br><br>
<blockquote type=cite class=cite cite="">I don't own a FT1000, so I can't
reproduce your problem, and not involved in the radios coding, but I'd
like to be sure I understand what's wrong.<br><br>
1/ You say you were using a FT1000 MP *and* a FT1000. Was it a SO2R
configuration ? Or did you tested them separately
?</font></blockquote><br>
I first noticed the problem with the FT1000 in the SO2R configuration;
the<br>
FT1000MP worked as it should. I then verified that it was just a
FT1000<br>
problem by testing them separately (SO1R). Win-Test worked as it
should with<br>
the FT1000MP but I had the problems described with the FT1000.<br><br>
<br>
<blockquote type=cite class=cite cite=""><font size=3>2/ From what I
understand, the "VFO display" on the upper part of the radio
bandmap was always correct (does this display follow when you're tuning
your radio ?), but the recorded freq of the entered QSO wasn't correct.
And if you entered a spot (Ctrl-Enter) the freq was not also the one
displayed on the bandmap ??? What if you do an Alt-F3 to send a spot to
the cluster ? Was the freq correct ? (You can try and cancel the sending
if you want)<br><br>
Please cfm these assumptions to ease bug
investigation.</font></blockquote><br>
The frequency display at the top of the Band Map does correctly
follow the<br>
FT1000 as it is tuned. Entering a call with Ctrl-Enter always
places it at the<br>
frequency of the last "grabbed" spot. Alt-F3 shows the
same frequency. If no<br>
spot was "grabbed" the call entered with Ctrl-Enter does not
seem to appear<br>
at all. Alt-F3 shows the lowest frequency on the band (7000,14000
etc).<br>
The recorded frequency of an entered QSO exhibits the same behavior.<br>
(last grabbed spot frequency or base band frequency if no spot
grabbed) <br><br>
<font size=3>Thank you very much for looking into this odd
problem.<br><br>
73 Pete - N8TR</font></body>
</html>